Mountfield SV150 Dokumentacja Pobierz pdf (Strona 33)

6.8 EXHAUST SYSTEM

GENERAL INFORMATION

The exhaust system consists of a muffler installed

on the cylinder together with a gasket, a spacer and

a heatproof baffle.

A malfunctioning exhaust system may lead to a loss

in power or excess noise. However, the muffler is a

preassembled part which cannot and must not be

disassembled or repaired but only replaced.

SERVICING PROCEDURES

A) Removing and replacing the muffler

1 Remove the conveyor with the tank [ 6.1.A

2 Remove the cover (1) secured by three screws

(2).

3 Unscrew the two nuts (3) and take out the muf-

fler (4), the heatproof baffle (5), the spacer (6)

and the gasket (7).

4 When mounting:

– thoroughly clean the cylinder contact surface,

removing all gasket fragments or deposits;

– always replace the gasket (7) and check that

the spacer (6) is intact;

– always replace the heatproof baffle (5) if it is

broken or cracked;

– tighten the two nuts (3) to the specified levels.

5 Remount the conveyor [ 6.1.A

Tightening torques

3 Muffler nuts .......................................... 6-8 Nm

SV 150

6.8.0

EXHAUST SYSTEM





1 / 1



WORKSHOP MANUAL

page

from

2004 to ••••

01/2005

<= ...BACK... <=

1 2 ... 28 29 30 31 32 33 34 35

Brak uwag

Mountfield SV150 Dokumentacja Strona 33